VERSALIFT VANTEL-29-NE non-insulated 28’ 10” telescopic aerial platform lift with a 33’ 10” working height, including:

• Standard platform capacity of 350 lbs.
• Heavy duty aluminum inner boom with drop down boom tip.
• Drop down boom tip including manual 180° positioner.
• Engine start/stop controls at platform and remote lower controls.
• Non-continuous 360 degree rotation with electric limit system.
• Two GPM. (7.57lpm) open center hydraulic system.
• Hydraulic oil reservoir with 7 gallon (26.5L) capacity built integral to pedestal.
• Self locking worm gear rotation drive with shear ball bearing.
• Boom articulation from 8 degrees below horizontal to 80 degrees above horizontal.
• Electric rotation limit system.
• Van mount pedestal and mounting hardware for PROMASTER van installation.
• Hand held remote lower controls including 30 ft. cable and override.
• Electric controls at platform including master control, emergency stop, and control cover.
• Hydraulic power supplied by engine belt drive system.
• Walk in hydraulic leveled 24 in. x 24 in. x 42 in. (.61m x .61m x 1.07m) end mounted fiberglass platform with door and vinyl cover
• Non-lube bearings used at all pivot points.
• Multi-link plastic hose carrier system through booms.
• 120V wiring to platform with GFCI receptacle.
• 12 volt DC backup pump.
• Safety harness and lanyard.
• Unit painted standard white urethane.
• Two operators and service manuals.
• ANSI A92.2 data plate.

Van specifications to include the following:

• 2023 Dodge Promaster 3500 Low Roof van.
• 136 in. Wheel base.
• 3.6L V6 24V VVT gasoline engine with 9-speed 948TE automatic transmission.
• Upfitter electronic module (VSIM).
• Auxiliary switches.
• Speed control.
• Vinyl dual bucket seats.
• Driver and passenger seats – manual adjust 6-way.
• Mopar slush mat front walk thru.
• Mopar side wall paneling.
• Wood floor in cargo area.
• Power folding/heated mirrors.
• Bright White Clear Coat Paint.

Installation to include the following:

• Install VERSALIFT VANTEL-29-NE, belt drive system and mounting hardware.
• Install and non-skid bumper extension.
• Install access step with center stop light on extension.
• Install SuperSprings on rear axle.
• Install cab partition, shelving system and roof ladder rack.
• Install two (2) turret mounted amber strobes.
• Install 2000 Watt inverter with one Group 31 battery including battery box
• Install parking brake interlock, back up alarm and bucket rest.
• Furnish rubber wheel chocks, fire extinguisher, first aid kit and 3 piece triangle warning kit
• Test ride completed unit for 1 Hour.
• Test and Certify per ANSI A92.2