VERSALIFT VANTEL-29-NE non-insulated 28’ 10” telescopic aerial platform lift with a 33’ 10” working height, including:
- Standard platform capacity of 350 lbs.
- Heavy duty aluminum inner boom with drop down boom tip.
- Drop down boom tip including manual 180° positioner.
- Engine start/stop controls at platform and remote lower controls.
- Non-continuous 360 degree rotation with electric limit system.
- Two GPM. (7.57lpm) open center hydraulic system.
- Hydraulic oil reservoir with 7 gallon (26.5L) capacity built integral to pedestal.
- Self locking worm gear rotation drive with shear ball bearing.
- Boom articulation from 8 degrees below horizontal to 80 degrees above horizontal.
- Electric rotation limit system.
- Van mount pedestal and mounting hardware for PROMASTER van installation.
- Hand held remote lower controls including 30 ft. cable and override.
- Electric controls at platform including master control, emergency stop, and control cover.
- Hydraulic power supplied by engine belt drive system.
- Walk in hydraulic leveled 24 in. x 24 in. x 42 in. (.61m x .61m x 1.07m) end mounted fiberglass platform with door and vinyl cover
- Non-lube bearings used at all pivot points.
- Multi-link plastic hose carrier system through booms.
- 120V wiring to platform with GFCI receptacle.
- 12 volt DC backup pump.
- Safety harness and lanyard.
- Unit painted standard white urethane.
- Two operators and service manuals.
- ANSI A92.2 data plate.
Van specifications to include the following:
- 2023 Dodge Promaster 3500 Low Roof van.
- 136 in. Wheel base.
- 6L V6 24V VVT gasoline engine with 9-speed 948TE automatic transmission.
- Upfitter electronic module (VSIM).
- Auxiliary switches.
- Speed control.
- Vinyl dual bucket seats.
- Driver and passenger seats – manual adjust 6-way.
- Mopar slush mat front walk thru.
- Mopar side wall paneling.
- Wood floor in cargo area.
- Power folding/heated mirrors.
- Bright White Clear Coat Paint.
Installation to include the following:
- Install VERSALIFT VANTEL-29-NE, belt drive system and mounting hardware.
- Install and non-skid bumper extension.
- Install access step with center stop light on extension.
- Install SuperSprings on rear axle.
- Install cab partition, shelving system and roof ladder rack.
- Install two (2) turret mounted amber strobes.
- Install 2000 Watt inverter with one Group 31 battery including battery box
- Install parking brake interlock, back up alarm and bucket rest.
- Furnish rubber wheel chocks, fire extinguisher, first aid kit and 3 piece triangle warning kit
- Test ride completed unit for 1 Hour.
- Test and Certify per ANSI A92.2